Language:

Partner Portal

Tech specs

DoorProtect Plus U Jeweller

Wireless reed-switch opening detector with shock and tilt sensors

DoorProtect Plus U Jeweller

Device compatibility

Check

Communication

Jeweller communication technology

Proprietary wireless communication technology to transmit commands, alarms, and events.

Key features:

  • Two-way communication.
  • Advanced sabotage protection.
  • Block encryption featuring a dynamic key.
  • Instant notifications.
  • Remote control and configuration in Ajax apps.

Frequency bands

868.0–868.6 MHz

Maximum effective radiated power (ERP)

up to 20 mW

Automatic power control to reduce power consumption and radio interference.

Radio signal modulation

GFSK

Radio communication range

up to 3,900 ft

Between the device and a hub (or a range extender) in an open space.

Encrypted communication

All stored and transmitted data is protected by block encryption featuring a dynamic key.

Frequency hopping

To prevent radio interference and jamming.

Detection

Sensitive elements

1 accelerometer
2 reed switches

The magnet can be installed to the left or right side of the detector.

Magnets

small and big one come in the set

The small magnet operates at a distance of up to 1 cm from the detector, and the big magnet — up to 2 cm.

Protection against reed switch chattering

The detector ignores vibrations lasting up to 0.15 s.

Input to connect an additional detector

Wired detector with the normally closed (NC) contact type.

Shock sensor sensitivity

3 levels

Option to ignore single shock

Adjusted by PRO or user with admin rights in the Ajax app.

Tilt sensor activation threshold

from 5° to 25°

Adjusted by PRO or user with admin rights in the Ajax app.

Chime

The siren makes a special sound to notify that the opening detectors are triggered when the system is disarmed.

Reed switch

Additional detector connection

Shock sensor sensitivity

Recommendations

Do not install the detector using both magnets at the same time. The detector recognizes only one magnet on one side of the detector — left or right.
For indoor use only.

Sabotage protection

Tamper alarm

Notifications on attempts to detach the detector from the surface or remove it from the mounting panel.

Holding screw

to secure the detector on SmartBracket

Protection against spoofing

device authentication

Communication loss detection

after 36 s

Detection time depends on the Jeweller or Jeweller/Fibra settings.

Power supply

Battery

1 × CR123A

Pre-installed.

Type

type C

Calculated battery life

up to 5 years

Operating voltage range

2.1−3.3 V⎓

Nominal operating voltage

3 V⎓

Quiescent current consumption at nominal voltage

0.013 mA

Maximum current consumption at nominal voltage

10.5 mA

Full battery capacity

1,600 mAh

Low battery voltage

2.5 V⎓

Low battery recovery voltage

2.7 V⎓

End-of-life battery voltage

2.1 V⎓

Device is switched off.

End-of-life battery capacity

300 mAh

Manufacturer

Panasonic

Enclosure

Dimensions

103 × 22 × 21 mm

Dimensions of the big magnet

103 × 22 × 21 mm

Dimensions of the small magnet

55 × 11 × 6 mm

Weight of the white device

37 g

Weight of the black device

34 g

Operating temperature range

from −10 °C to +40 °C

Operating humidity

up to 75%

Protection class

IP50, IK04

Colors

Black

White

Complete set

DoorProtect Plus U Jeweller

SmartBracket mounting panel with holding screw

CR123A battery (pre-installed)

Big magnet

Small magnet

Outside-mounted terminal clamp

Installation kit

Quick start guide

Certification and compliance with standards

DoorProtect Plus U Jeweller

DoorProtect Plus U Jeweller

Compliance with the security alarm standards

Certificate issued by TREZOR TEST s.r.o.

EN 50131-1:2006/A1:2009/А2:2017/A3:2020

EN 50131-2-6:2008

EN 50131-2-8:2016

EN 50131-5-3:2017

EN 50131-6:2017/A1:2021**

PD 6662:2017*

Security Grade (SG)

Certificate issued by TREZOR TEST s.r.o.

2

Radio Equipment Directive (RED)

Certificate issued by MiCOM Labs

EN 300 220-1 V3.1.1

EN 300 220-2 V3.2.1

Restriction of Hazardous Substances Directive (RoHS)

Test report issued by Shenzhen NTEK Testing Technology Co.

EN IEC 63000:2018

Electromagnetic Compatibility Directive (EMC)

Certificate issued by MiCOM Labs

EN 301 489-1 V2.2.3

EN 301 489-3 V2.1.1

Low Voltage Directive (LVD)

Certificate issued by TREZOR TEST s.r.o.

EN 62479:2010

EN 62368-1:2020/A11:2020

Environmental class according to EN 50131

Certificate issued by TREZOR TEST s.r.o.

||

PSTI UK

BSI Assurance UK Limited

Schedule 1

Additional information

Compliance with standards

Learn more

Warranty

24 months

Learn more

User manual

Learn more